![]() It is located inside the motor area, next to the pulley on the front roller. It sounds like the speed sensor is not close enough to the magnet, or the speed sensor is bad. You should have to take a few steps before the belt stops - if it stops suddenly there is probably a high friction problem.Įxcessive belt-deck friction can also cause motor to stall or sound labored so again, keep your belt and deck free from dust and dirct and look out if this is a problem Posted on Jan 26, 2011. Press the stop button (or pull the emergency stop switch). You can check for excessive belt-deck friction by setting your treadmill around 4 MPH and walking on it. This in turn, can damage your electronics and even your motor. Dirt and dust build-up, especially between the belt and the deck of your treadmill can cause excessive belt-deck friction. One of the ways to extend the life of your treadmill is to keep it clean and dust-free. 1216 Answers SOURCE: surely there is some problem in the belt.OWNER’S MANUAL Please carefully read this entire manual before operating your new treadmill. › █ █ █ Dyaco Treadmill Model 909 Manual █ █ █ ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |